What our customers are saying:

Documented quality and savings

"Our gear shavers showed an average increase of two and one half times over an untreated gear shaver."
   - Major earthmoving equipment company

"We ran more than 40 races for the 1991 season between lower engine teardowns. Before Cryo-Processing, we had to tear down after every six to seven events."
   - National auto racer

"We are saving in excess of $5 million annually on milling by doubling our tooling output."
   - Major commercial aircraft manufacturer

"We use cryogenic processing because it develops a more uniform refined microstructure with greater density and releases internal stresses."
   - NASA consultant

"Our progressive dies last six times longer."
   - Major automotive supplier

"Our taps last three to four times longer, but our punches went from 25,000 hits to over 120,000 hits. Incredible!"
   - Punch manufacturer

" We treated a die that usually required replacement after 7,000 pieces, after Cryo-Processing, we worked for an incredible 193,000 pieces!"
   - Forging manufacturer

All pages and images contained on this site are © 2006 Cryogenic Engineering Inc.,
and are protected by the copyright laws of the United States of America, and the Internet Copyright Act.